GF2 Hack Installation

[jp]

Hi,
I'm a newbie trying to install the GF2 hack and can't figure out Step 7 (cut and pasted below) from the "EOSHD GH2/GF2 Installation Guide:

"7. Notice the round buttons at the bottom of PTools and click preset[b] ‘E’ [/b]for EOSHD GH2 Unified or [b]‘F’ [/b]to load EOSHD GH2 Vanilla"

Should I be clicking the "E" or the "F" or a different letter? (its not written in the instructions)

Thanks for any assistance.

Cheers,

Jes

[Chris Mann]

You click the button that corresponds to the preset that you want to have loaded into the firmware.

So if you want to use the settings that are defined in the Unified preset, click button E; to use the Vanilla preset, click button F.

Those two buttons are used in case you have downloaded other presets that assign themselves to buttons A-D.

[jp]

Thanks for the help.. My mistake was I didn't have the ptools in the same folder as the setg.ini and it ended up being the "g" that lit up..